• All my experience is with IMR 4198 and Ramshot TAC. TAC flowed and metered a bit superior, but 4198 grouped much better, shot softer and left the gun cleaner. And

It truly is anecdotal, but for what its value when comparing wc844 to tac both loaded to 5.56 pressures inside of a 11.5 barrel, WC844 can make some good fireballs in which with tac it is almost non-existant. Presented the place tac and h335 slide over the burn price chart I might have imagined it would have been the alternative.

004 lengthier than any of my other fired situations applying Hornandy gauge, so I checked some outdated circumstances and shot a couple of factory Winchester rounds to make certain and positive more than enough the ttsx's i just loaded had more head space extend or duration by a .004

You may obtain an e mail each and every Friday morning that includes the most recent chatter from the hottest matters, breaking news surrounding legislation, in addition to special specials only available to ARFCOM e mail subscribers.

I have shot loads of WC844 (armed service comparable to H335) and WC846 (military services W748 or BallC2) and have not experienced the slightest hint of ignition difficulties.   Poodleshooter

H335 is my drop by powder for my Marlin 35 Rem. Lever gun loves this stuff. Haven't tried using it in any other caliber.

Next time you dump H335 in a very 223 case, lightly contact the case from a jogging tumbler. It will eventually settle the powder column down. Performs properly for powder/cartridge combos which have been almost always compressed loads (Varget and .223!)

Individually, my practical experience and impression of the two powders has been just about the opposite of yours. CFE 223 will conduct far better the longer your barrel is plus the heavier the bullet you employ. My views are that CFE 223 is correct on the verge of being much too gradual of the powder to even use in 223.

Thanks Dryflash! This thread has my curiosity peaked somewhat as to how the Wolf 55gr bullets will do with TAC. I can have to try to get the job done up a load and find out how they are doing.

I only wish i could offer several of my oops'es in powder i have piled up. Was nearsighted to start with round and have a read more LB of 332 in the home,Unsure what thats very good for.Loaded about twenty rounds with that and resolved that was out.

I understand Speer accustomed to recommend them in their manuals for selected ball powders, but I've under no circumstances truly noticed anyone else endorse it.

This isn’t uncommon as I’ve noticed the disparity in load suggestions throughout my 40 a long time of reloading. But it doesn’t harm to ask.

I "browse over the internet" that early 335 was some kind of sluggish burning pull down powder but newer heaps within the plastic cans are quite a bit faster.

Posts: four,615 I am also extremely stubborn to halt utilizing 4064. Regardless that I know there incredibly nicely could be greater options, I similar to it and its often offered and its great across a lot of calibers old and new. But I do listen to the CFE is an ideal option for mid-significant bullets like 69gr.